高级检索

氧介导原位提升多孔NiCrCo中熵合金高温抗氧化性能

Oxygen-mediated in-situ improvement on high temperature oxidation resistance of porous NiCrCo medium entropy alloys

  • 摘要: 针对高性能NiCrCo中熵合金在高温轻量化构件应用中面临的抗氧化性能退化问题,采用粉末冶金方法制备了多孔NiCrCo合金,通过粉末混料阶段引入微量醋酸铬乙醇溶液,实现氧扩散行为的定向调控以及Cr2O3陶瓷颗粒在合金基体中的整体原位预弥散分布,提高合金的高温抗氧化性能。在700~1100 ℃保温20 h条件下,系统研究了多孔NiCrCo合金的高温氧化行为及其氧化机制。分析表明,通过调控放电等离子烧结压力(3~15 MPa),可实现合金孔隙率在6.3%~18.9%可控调节,并促进Cr2O3颗粒在局部孔隙边缘区域均匀分布。随着氧化温度升高,氧化产物呈现明显的温度依赖性演变,其中氧化层/基体界面处主要形成连续Cr2O3保护层,同时NiCr2O4和CoCr2O4尖晶石氧化物含量随温度升高逐渐增加。结合多孔结构特征、氧化过程中物相演变及微观组织变化,揭示了多孔NiCrCo合金的高温氧化机制,明确了预制备过程中形成的Cr2O3氧化陶瓷相对氧扩散行为及氧化膜稳定性的调控作用。通过主动引入具有保护作用的氧化陶瓷相,可实现对合金高温严苛环境中氧化现象的防护调控,在一定程度上突破了传统金属氧化导致材料性能退化的认知,为高温轻量化结构材料的设计提供了新思路。

     

    Abstract: To address the degradation of oxidation resistance for the high-performance NiCrCo medium-entropy alloys used in high-temperature lightweight components, the high temperature oxidation resistance of the porous NiCrCo medium entropy alloys prepared by powder metallurgy method was studied in this paper. By introducing trace amount of chromium acetate ethanol solution during the powder mixing stage, the directionally regulated oxygen diffusion behavior and in-situ pre-dispersion distribution of Cr2O3 ceramic particles in alloy matrix were accomplished. The high-temperature oxidation behavior of the porous NiCrCo alloys followed by isothermal oxidation at 700~1100 ℃ for 20 h was systematically investigated. In consideration of the porous structural characteristic, phase evolution, and microstructural change during oxidation, the high-temperature oxidation mechanism of the porous NiCrCo alloys was revealed. The results demonstrate that the porosity can be meticulously regulated within the range of 6.3%~18.9% by means of adjusting the spark plasma sintering pressure from 3 to 15 MPa, and the Cr2O3 particles are distributed uniformly along the edges of the localized pores. As the oxidation temperature increases, the oxidation products exhibit the significant temperature-dependent evolution. The formation of continuous protective Cr2O3 layer occurs primarily at the oxide scale/substrate interface. Concurrently, the contents of the spinel NiCr2O4 and CoCr2O4 oxides undergo the gradual increase with increasing temperature. The preformed Cr2O3 ceramic phases are demonstrated to regulate oxygen diffusion and improve the oxide scale stability. The deliberate introduction of protective oxide ceramic phases can effectively regulate the high-temperature oxidation process and alleviate the oxidation-induced performance degradation, providing a new approach for the design of lightweight structural materials for high-temperature applications.

     

/

返回文章
返回