Abstract:
To address the issues of continuous epitaxial growth, obvious texture, and insufficient plasticity of coarse columnar β crystals in the deposited microstructure of laser directed energy deposition (L-DED) TA15 titanium alloy, and the limitations of current research focusing on bimetallic structures prepared by composite different alloy compositions and the low plasticity of single process parameters, this study proposes a method for preparing TA15 titanium alloy specimens using constant scanning speeds of 600, 900, and 1200 mm/min and alternating layered scanning speeds of 600×900 mm/min. Results show that in the constant scanning rate samples, the original β grains mainly grow continuously along the deposition direction, forming columnar crystals that penetrate multiple layers; The layered alternating scanning speed samples periodically change the heat input of the melt pool, partially preserving the CET equiaxed crystal region at the top of the previous layer, thereby blocking continuous epitaxial growth of β grains and promoting near-equiaxation. The average thickness of the α layer thickness of the layered alternating scanning speed samples dropped to 0.271 μm,forming a dense and interlaced ultrafine mesh basket microstructure. Room temperature tensile results showed that the elongation at break of 600×900 mm/min reached 12.9%, an increase of 43.3%, 53.6%, and 69.7% compared to the three constant scanning speed samples. Significantly improving plasticity while maintaining a high strength level to achieve the comprehensive optimization of strength and plasticity mainly stems from the near-equiaxed β grains weakening the texture and improving deformation coordination. The ultrafine α mesh basket microstructure enhanced strength and crack resistance through dense interfaces, periodic thermal stress activated <C+A> total dislocations to enhance c-axis deformation capability, and the dispersed nano β phase maintains work hardening and alleviated stress concentration through heteromorphic deformation. This result provides a feasible process route for improving and optimizing the plasticity of L-DED TA15 titanium alloy without changing its composition.